HSRP Configuration Hot Standby Router Protocol CCNA 200301 YouTube

Lacp Hot Standby. LACP and Active/Standby Operation Each port that is configured to use LACP has an LACP port priority Here is the status of the enterchannel: HQC4#sh etherchannel 2 summ Flags: D - down P - bundled in port-channel I - stand-alone s - suspended H - Hot-standby (LACP only)

The software places any additional links in a hot-standby mode. Switch1#show etherchannel summary Flags: D - down P - bundled in port-channel I - stand-alone s - suspended H - Hot-standby (LACP only) R - Layer3 S - Layer2 U - in use N - not in use, no aggregation f - failed to allocate aggregator M - not in use, minimum links not met m - not in use, port not aggregated due to minimum links not met u.

Set up Hot Standby

Each port that is configured to use LACP has an LACP port priority Here is the status of the enterchannel: HQC4#sh etherchannel 2 summ Flags: D - down P - bundled in port-channel I - stand-alone s - suspended H - Hot-standby (LACP only) Configuring LACP Hot-Standby Ports, Configuring the LACP System Priority, Configuring the LACP Port Priority

LACP and Active/Standby Operation. The software places any additional links in a hot-standby mode When enabled, LACP tries to configure the maximum number of LACP-compatible ports in a channel, up to a maximum of 16 ports

CCNA DAY 48 How to Configure HSRP on a Cisco Router Hot Standby. If one of the active links becomes inactive, a link that is in the hot. LACP allows for up to 16 ports to be configure to be part of a port channel but only 8 are active at any point in time and the others are in a hot standby state